Kairox DIY Calc

Flooring and finishing

Tile Calculator

Estimate individual tiles for a rectangular floor or wall using actual tile dimensions. The result is an area-based purchase estimate with a cutting allowance, so compare it with a drawn layout before ordering cartons.

Enter your measurements

ft
ft
in
in
%

Example estimate

Project area (sq ft)
120
Area with allowance (sq ft)
132
Whole pieces to order (area estimate)
132

Estimates only. Whole purchase counts round up; displayed measurements round to four decimal places. The allowance is an editable planning assumption.

How the calculation works

Floor area = length × width. Tile area(ft²) = tile length(in) × tile width(in) ÷ 144. Pieces = ceiling(floor area × (1 + allowance/100) ÷ tile area).

Measure the surface to be tiled

Use the dimensions of the finished tiled footprint. A room with a recess or adjoining closet is easier to check as separate rectangles. Decide which permanent obstructions will remain untiled and account for them consistently in your takeoff. For wall tile, length and width simply describe the two dimensions of the tiled surface; they do not need to represent a floor.

Use dimensions that describe the actual product

Enter the face length and width of a single tile, keeping inches separate from feet. A named tile size may be a nominal description rather than the exact face measurement. Check the packaging or manufacturer specification. This tool divides total surface area by face area; it does not simulate a layout or assume that offcuts from one edge will fit another edge.

Choose an allowance from your layout

The allowance is an adjustable estimate for cuts and spare pieces, not a fixed rule. A straight layout in a simple rectangle may use pieces differently from a diagonal pattern, a border, or a room with many small corners. Inspect the planned cuts before settling on the percentage. The calculator rounds the final individual count up even when the allowance is zero.

Convert pieces into the right purchase unit

If the store sells only full cartons, divide the calculated piece count by the pieces per carton and round up again. Keep the carton label with your estimate so another person can reproduce that conversion. For multi-size pattern packs, use the manufacturer’s coverage per pack instead of assuming all pieces have the same dimensions. This form models one uniform rectangular tile size.

Keep setting materials on a separate list

Grout, mortar, waterproofing, movement joints, trim, and substrate preparation require product-specific information. Grout joint width is not deducted from the face-area estimate here; it belongs in the actual layout. A quantity of tile does not show that a surface is suitable for installation. Check the assembly and product instructions before purchasing materials that depend on the condition of the wall or floor.

Worked example

The example uses square tiles in a rectangular room and an explicitly stated extra-material allowance. Compare the net surface area with the area including that allowance, then read the whole-piece result. Changing only tile dimensions shows how product format affects the estimated count without changing the room itself.

Example inputs — Length: 12 ft; Width: 10 ft; Tile length: 12 in; Tile width: 12 in; Extra material allowance (planning estimate): 10 %.

Calculated example

Project area (sq ft)
120
Area with allowance (sq ft)
132
Whole pieces to order (area estimate)
132

Frequently asked questions

Does this calculate grout?

No. Grout quantity depends on joint width, tile thickness, layout, and the chosen grout’s published yield. Use the product’s coverage guidance after the tile layout has been settled.

Why should I still draw the layout?

An area total cannot reveal narrow edge cuts, pattern alignment, or reusable offcuts. A layout also helps you decide where full tiles and visible cut edges will fall.

Can I use it for mosaic sheets?

Only as a rough area comparison if the entered dimensions describe one usable sheet. Check the sheet’s stated coverage and joint arrangement; individual mosaic pieces are not counted by this model.

Sources and scope