Kairox DIY Calc

Building and framing

Roof Pitch Calculator

Convert vertical rise and horizontal run into a rise-per-twelve pitch, an angle, and a slope multiplier. Use measurements taken in the same plane; the sloping surface length is not the horizontal run.

Enter your measurements

in
in

Example estimate

Rise per 12 inches of run
6
Pitch angle (degrees)
26.5651
Slope length multiplier
1.118

Estimates only. Whole purchase counts round up; displayed measurements round to four decimal places. The allowance is an editable planning assumption.

How the calculation works

Ratio = rise ÷ horizontal run (same units). Pitch = 12 × ratio. Angle(degrees) = atan(ratio) × 180 ÷ π. Slope multiplier = √(1 + ratio²).

Separate horizontal run from slope length

The run is the level distance beneath the sloping segment. Rise is the vertical change across that same distance. Measuring along a rafter and entering that distance as run mixes two different sides of the triangle. If you already know a pitch such as six in twelve, enter six for rise and twelve for run with matching units to inspect the corresponding angle and multiplier.

Read a pitch as a ratio

A rise-per-twelve result describes how far the roof rises for twelve horizontal units. The units can be inches, feet, or another consistent measure because the ratio is unchanged. The angle uses the inverse tangent of rise divided by run. It is expressed in degrees. The slope multiplier is the ratio between the sloping line and its horizontal projection, derived from the same right triangle.

Use the multiplier with the correct footprint

Multiplying a horizontal length by the slope multiplier gives a sloping length for that constant pitch. A uniformly pitched roof plane can use the same relationship between projected area and sloped area. That relationship does not account for roof overhangs missing from your footprint, openings, separate pitches, or cutting losses. Keep those adjustments visible rather than hiding them in an unexplained multiplier.

Take measurements without relying on a roof climb

Use a safe, accessible measurement method or information from reliable plans. This tool is not a reason to enter an unsafe location. A short measurement can magnify small reading errors, so repeat observations when possible and record the method. Check that the rise and run refer to the same segment rather than mixing dimensions from different sides of a building.

Do not infer product suitability from geometry

Roof covering suitability, drainage design, snow loading, and framing capacity cannot be decided from pitch alone. Review product instructions and local requirements with a qualified professional. A zero-rise input is accepted as a mathematical case, but a zero angle is not a recommendation for a roof assembly. The tool reports the entered geometry and does not choose an acceptable construction system.

Worked example

The default rise and run describe a six-in-twelve slope. The same ratio drives all three outputs, so the displayed angle and multiplier cannot drift apart through separate lookup tables. Use the rafter length calculator when you want to apply that pitch to a specific horizontal span and overhang.

Example inputs — Vertical rise: 6 in; Horizontal run: 12 in.

Calculated example

Rise per 12 inches of run
6
Pitch angle (degrees)
26.5651
Slope length multiplier
1.118

Frequently asked questions

Can the rise be zero?

Yes. The mathematical result is zero pitch, zero degrees, and a multiplier of one. A positive horizontal run is still required, and the output does not establish acceptable roof drainage.

Why is pitch different from angle?

Pitch here is a rise-per-twelve ratio, while angle is measured in degrees from horizontal. They describe the same slope with different notation and cannot be substituted numerically.

Will the result estimate roof bundles?

No. Bundle coverage, cutting layout, laps, starter material, and separate roof planes require additional information. This page supplies geometry rather than a roofing product order.

Sources and scope