How the calculation works
Board feet = thickness(in) × width(in) × length(ft) × number of boards ÷ 12.
Understand the unit before comparing prices
A board foot is a volume of 144 cubic inches, as defined by the Virginia Department of Forestry. A board one inch thick, twelve inches wide, and one foot long contains one board foot. A narrower or thinner board can contain the same volume if it is long enough. The result does not tell you whether a board can supply a particular finished part.
Enter a consistent size basis
Ask the seller whether the quoted tally uses rough, nominal, or measured dimensions. Enter the dimensions appropriate to that tally rather than silently substituting a finished size. This matters when you compare a seller’s invoice with your own calculation. The tool accepts thickness and width in inches and length in feet, and it shows every part of that conversion in the formula.
Keep different board sizes separate
The count field represents identical pieces. If your stack includes several widths or lengths, calculate each group separately and add the board-foot results. Do not multiply an average length by an average width unless you have checked that this represents the actual stock. A short wide board and a long narrow board can make that shortcut misleading even if the averages look reasonable.
Plan for usable material
Purchased volume and useful project yield are different quantities. Knots, checks, grain direction, jointing, and the placement of your cuts can affect which parts a board will provide. Make a cutting list and compare it with the available boards. This tool deliberately does not invent a universal waste allowance for hardwood selection. Add any extra stock as an explicit purchasing choice after reviewing your layout.
Read the result as volume, not a piece count
Board-foot results can be fractional, so the calculator does not round them into whole boards. If a yard charges by board foot, multiply its confirmed tally by its current unit price to compare costs. Check minimum billed lengths or other seller conventions independently. A matching mathematical volume does not establish grading, moisture condition, species, or suitability for structural use.
Worked example
The default batch uses one thickness, one width, one length, and a whole-number board count. The rendered result below is the total volume of the batch, not the volume of just one board. Change the count to one to inspect the per-board amount before returning to the full order.
Example inputs — Board thickness: 1 in; Board width: 6 in; Board length: 8 ft; Number of identical boards: 10.
Calculated example
- Board feet
- 40
Frequently asked questions
Is board foot the same as square foot?
No. Square feet measure surface area. Board feet include thickness. Two boards with the same face area but different thicknesses contain different board-foot volumes.
Can I enter a fractional board count?
No. Enter a whole number of identical boards. Fractional dimensions are fine, but the count field describes actual pieces rather than an equivalent volume.
Can I use this for a mixed stack?
Yes, one size group at a time. Record each result, then sum the board feet. Keep the original dimensions with your notes so the tally can be checked against the seller’s method.
Sources and scope
- Virginia Department of Forestry — Board Foot — One board foot is 144 cubic inches. Accessed 2026-11-20.
- NIST Guide to the SI — Appendix B.8: Conversion Factors — Length, area, volume, and mass conversion definitions. Accessed 2026-11-20.