How the calculation works
Area(ft²): rectangle = length × width; circle = π × (diameter/2)²; triangle = base × perpendicular height ÷ 2. Cubic feet = area × depth(in) ÷ 12. Cubic yards = cubic feet ÷ 27. Order volume = cubic yards × (1 + allowance/100).
Pick the footprint, then the depth
Choose the shape that matches your plan view. For a rectangle, enter its length and width. For a circle, enter the diameter in the first dimension field; the width field is ignored. For a triangle, use the base and its perpendicular height. Depth is the thickness of the material layer measured at right angles to that footprint, not a sloping edge length.
Understand a cubic yard
A yard contains three feet. A cube measuring three feet on every edge therefore contains twenty-seven cubic feet. That is why the calculator divides cubic feet by twenty-seven rather than by three. When depth is entered in inches, it is first divided by twelve to put all three dimensions into feet. Multiplying lengths expressed in mixed units without that conversion gives the wrong volume.
Break up an irregular space
A curved bed can often be approximated with several simple shapes. Draw the sections so they do not overlap, calculate each one, and add the volumes. For an opening or island, calculate its volume separately and subtract it on your worksheet. A triangle’s height must meet the base at a right angle; the length of a sloping side is not an interchangeable substitute.
Use depth carefully
A shallow layer over a large footprint can still require substantial material. Take depth measurements in several places when filling an uneven area. The tool assumes a uniform layer, so it cannot determine how much is needed to level a surface from a single deepest point. Separate calculations for shallow and deep zones are more informative than an unexplained guess at the entire area.
From volume to a purchase
The net cubic yards are geometric volume. The order volume adds your chosen extra-material percentage, which is an editable planning estimate. A bulk yard may sell only in particular increments, so round the final order to its actual policy. To buy packaged material, use a tool that divides volume by the labeled bag yield. To buy by weight, obtain a material-specific density first.
Worked example
The initial rectangular example uses ordinary dimensions so the conversion is easy to follow. Read the net volume first, then compare the larger order volume after the selected allowance. Changing the shape changes the area calculation while leaving the depth conversion and cubic-yard conversion the same.
Example inputs — Plan shape: rectangle; Length, triangle base, or circle diameter: 12 ft; Width or triangle perpendicular height (ignored for circle): 10 ft; Depth: 3 in; Extra material allowance (planning estimate): 10 %.
Calculated example
- Net volume (cu ft)
- 30
- Net volume (cu yd)
- 1.1111
- Order volume (cu yd, before supplier increment)
- 1.2222
Frequently asked questions
Should I enter a radius or diameter?
Enter the full diameter for a circle. The formula halves it internally before squaring the radius. Entering a radius in that field produces a circle with one quarter of the intended area.
Is a cubic yard the same as a ton?
No. One is volume and the other is weight. Their relationship depends on the material’s bulk density, including the condition in which that density was measured.
Can I calculate several layers?
Yes, calculate each thickness separately. Keep gravel, sand, soil, and other layers on separate lines because their order units and adjustments may differ even when their footprints match.
Sources and scope
- NIST Guide to the SI — Appendix B.8: Conversion Factors — Length, area, volume, and mass conversion definitions. Accessed 2026-11-20.